# All Results & Reporting Q&A

> What You'll Learn on This Page This section outlines common questions about analyzing simulation results and generating reports. It explains how to

Part of the [MazeBolt Help Center](https://support.mazebolt.com/) › [FAQs](https://support.mazebolt.com/faqs). Updated 2025-12-22. HTML page: https://support.mazebolt.com/faqs/all-results-reporting-q-a

---

## What You'll Learn on This Page

This section outlines common questions about analyzing simulation results and generating reports. It explains how to interpret outcomes, access detailed reporting, and use insights to improve mitigation strategies and demonstrate resilience to stakeholders.

### Why do I see a cut-off when it is not visible as a deviation on the Target Response Monitoring graph?

The **Target Response Monitoring** graph provides an aggregated view of data collected from multiple monitoring nodes within a cloud region. A cut-off can occur even when a deviation is detected on only a single monitoring node. In such cases, the deviation may be sufficient to trigger the cut-off yet remain too small to be clearly visible in the aggregated graph.

### How can I view previous results?

To view results, navigate to the **Simulation Results** page and use the available filters to display the historical data you need data.

### Why do I see “0 Sent” under CPS?

The CPS (Connections Per Second) metric reflects the number of connections successfully opened. In some cases, mitigation measures may block connections before they are established, resulting in a value of “0 Sent.” In such a scenario, the underlying sent traffic can still be reviewed by switching the rate graph metric to **PPS (Packets Per Second)**.

### Why is the Received traffic higher than the Sent traffic?

There are several possible reasons for this behavior:
1\. **Mirror port misconfiguration** – Some traffic may be mirrored more than once, resulting in inflated received values.
2\. **Network device duplication** – Certain network devices can duplicate traffic. In the event of a real DDoS attack, this duplication could amplify the impact and increase the risk of downtime.

### How soon are simulation results available after a test completes?

Results are generated and displayed in the **Simulation Results** page immediately after the simulation ends. Vendor reports can be downloaded as soon as the data is processed.

### What is the difference between the Executive Report and the Vendor Report?

The **Executive Report** provides a high-level summary suitable for management and stakeholders and is issued quarterly.
The **Vendor Report** contains detailed technical data to help your mitigation provider fine-tune defenses and can be generated at any time.

### How do I interpret a “Partially Protected” result?

A **Partially Protected** status indicates that mitigation was only partially effective. This often points to configuration gaps or inconsistent policy enforcement and should be addressed promptly.

### Can I customize the data shown in exported reports?

Yes. Customization is available for **Vendor Reports** and **CSV exports**. Before generating a report, apply the desired filters to include only the data relevant to your analysis.
