# All Simulations & Scheduling Q&A

> What You'll Learn on This Page This section outlines common questions about running simulations. It provides guidance on starting, stopping, and managing

Part of the [MazeBolt Help Center](https://support.mazebolt.com/) › [FAQs](https://support.mazebolt.com/faqs). Updated 2026-07-28. HTML page: https://support.mazebolt.com/faqs/all-simulations-scheduling-q-a

---

## What You'll Learn on This Page

This section outlines common questions about running simulations. It provides guidance on starting, stopping, and managing simulations under different conditions, ensuring that tests are both effective and nondisruptive.

### How do I stop a simulation?

On the **Live Simulation** page, use the action buttons at the top. Click **Stop Simulation** to stop the **current simulation** within the cycle. The cycle itself remains active and will proceed to the next scheduled simulation, if applicable.

### How do I stop a simulation cycle?

On the **Live Simulation** page, use the action buttons at the top. Click **End Cycle** to terminate the entire simulation cycle, canceling any remaining simulations in that cycle.

### Why did a simulation fail to start?

To ensure simulations are nondisruptive and reliable, RADAR performs the following safety checks before starting a simulation:

- **Monitor Stability Check** – RADAR initiates stability checks by sending legitimate traffic to the target. This check ensures the target is stable before the simulation begins.
- **Diagnostic Test Validation** – RADAR initiates a diagnostic test by sending legitimate traffic to the target. This confirms that the detector is properly receiving traffic.

**Note:** If any of the above checks fail, the simulation will not be initiated. It will be marked as **Unchecked**, and RADAR will automatically proceed to the next scheduled simulation in the queue.

### Where do the attack IPs originate from?

Attack traffic is generated from a distributed cloud infrastructure. If required, customers may request that simulations originate from a specific region.

### How do I schedule recurring simulations?

On the **Scheduler** page, open the **Schedule** tab within the event settings and specify the required start times and recurrence pattern. This ensures your mitigation posture is validated on a regular basis without the need for manual intervention.

### Can I modify a simulation after it has been scheduled?

Yes. A scheduled simulation can be edited or rescheduled from the **Scheduler** page at any time before it starts. Simply open the **event settings**, adjust the parameters, and save your changes.

### What is the difference between Standard Assessment and Remediation Session?

- **Standard Assessment** provides a full visibility check across your environment by simulating attacks on all selected Targets x attack vector x Security Layer combinations. It’s ideal for initial evaluations or regular assessments to measure DDoS resilience and identify vulnerabilities.
- **Remediation Session** enables **real-time testing and validation**. Attack nodes remain active so you can re-run the same simulation to confirm that mitigation changes are effective. To start a remediation session, go to **Simulation Results**, find your target, and click **Re-simulate**.

### What is SmartCycle?

SmartCycle is an AI-powered engine within RADAR that prioritizes the order in which DDoS attack vectors are tested during a simulation.
It prioritizes which existing attack vectors and targets are most likely to bypass the organization's defenses, so those are tested first.

### How does SmartCycle decide which vectors to test first?

SmartCycle is trained on MazeBolt's vulnerability data and predicts which attack vectors are most likely to bypass an organization's specific defenses, then dynamically sequences simulations.

### Does SmartCycle replace RADAR's core testing?

No. SmartCycle is an enhancement to RADAR's existing simulation engine. It changes the sequence of testing, not the RADAR platform or its coverage.
