# All Targets & Monitors Q&A

> What You'll Learn on This Page This section outlines common questions about configuring and managing Targets and Monitors within the platform. What does

Part of the [MazeBolt Help Center](https://support.mazebolt.com/) › [FAQs](https://support.mazebolt.com/faqs). Updated 2026-08-02. HTML page: https://support.mazebolt.com/faqs/all-targets-monitors-q-a

---

## What You'll Learn on This Page

This section outlines common questions about configuring and managing Targets and Monitors within the platform.

### What does each monitor status color represent?

- **Checking (Gray):** The system is still collecting monitoring probe data, or there are no monitoring regions available. This status appears when the number of collected probes is below the threshold.
- **Down (Red):** A high number of monitoring probes have values that fall outside the defined thresholds on both upper and bottom baselines.
- **Unstable (Orange):** Many monitoring probe values deviate from the defined baseline thresholds, but not enough to be classified as down.
- **Stable (Green):** The number of monitoring probes is sufficient, and most values are within the expected baseline range.

### Why are fewer attack vector options available for a Target configured with CDN access?

Targets configured with access type CDN (i.e., Targets routed through a CDN) only support a subset of attack vectors. Other vectors are excluded because they are not applicable in this configuration.
For example, Layer 3 and Layer 4 vectors cannot be tested against a Target located downstream of a CDN.
For a comprehensive list of **CDN-applicable attack vectors**, refer to [**RADAR Supported DDoS Attack Vectors**](https://support.mazebolt.com/ddos-simulation/radar-supported-ddos-attack-vectors) which details all vectors that can be tested when a Target is configured with CDN access.

### On the Network Interface page, what does each status mean?

The Interface page uses three status indicators:

- **Unused** – The interface is not configured in RADAR.
- **Error** – Recent diagnostics on the mirror port have failed, indicating a mirroring issue.
- **OK** – The interface is configured correctly and mirror traffic is functioning as expected.

### What is the difference between Active and Inactive Monitor States?

On the **Targets** page, when adding or editing a target, navigate to the Monitors tab:

**Active:** The monitor is currently assigned to the selected Target.

**Inactive:** The monitor was previously assigned to the Target but is no longer assigned to it.
