Help Center
Contact us

All Targets & Monitors Q&A

On this page

What You'll Learn on This Page

This section outlines common questions about configuring and managing Targets and Monitors within the platform.

What does each monitor status color represent?
  • Checking (Gray): The system is still collecting monitoring probe data, or there are no monitoring regions available. This status appears when the number of collected probes is below the threshold.
  • Down (Red): A high number of monitoring probes have values that fall outside the defined thresholds on both upper and bottom baselines.
  • Unstable (Orange): Many monitoring probe values deviate from the defined baseline thresholds, but not enough to be classified as down.
  • Stable (Green): The number of monitoring probes is sufficient, and most values are within the expected baseline range.
Why are fewer attack vector options available for a Target configured with CDN access?

Targets configured with access type CDN (i.e., Targets routed through a CDN) only support a subset of attack vectors. Other vectors are excluded because they are not applicable in this configuration.
For example, Layer 3 and Layer 4 vectors cannot be tested against a Target located downstream of a CDN.
For a comprehensive list of CDN-applicable attack vectors, refer to RADAR Supported DDoS Attack Vectors which details all vectors that can be tested when a Target is configured with CDN access.

On the Network Interface page, what does each status mean?

The Interface page uses three status indicators:

  • Unused – The interface is not configured in RADAR.
  • Error – Recent diagnostics on the mirror port have failed, indicating a mirroring issue.
  • OK – The interface is configured correctly and mirror traffic is functioning as expected.
What is the difference between Active and Inactive Monitor States?

On the Targets page, when adding or editing a target, navigate to the Monitors tab:

Active: The monitor is currently assigned to the selected Target.

Inactive: The monitor was previously assigned to the Target but is no longer assigned to it.

Was this article helpful?

Need further assistance? Contact support